The CSAK-20 2 ton electric forklift is rated for 2000kg and measures 2350mm long excluding the forks. Standard lifting height is 3000mm.
Its 60V electrical system uses five 70Ah maintenance-free lead-acid batteries, with a 4000W AC travel motor and 3000W AC hydraulic lifting motor.
CSAK-20 vs CSAF-20
Both models are rated for 2000kg and both list chassis length without the forks, so their published dimensions can be compared directly. The CSAK-20 is listed at 2350mm, 100mm shorter than the 2450mm CSAF-20.
The CSAK-20 is also heavier at 2900kg versus 2700kg. Both use a 4000W travel motor, but the CSAK-20 lists a 3000W hydraulic lifting motor while the CSAF-20 lists 4000W.
The axle description is different as well: CSAK-20 specifies a Cast Steel Full-Floating 220 Axle, while CSAF-20 lists a Cast Steel Suspended 220 Axle. Buyers choosing between the two should therefore compare chassis layout and hydraulic specification rather than treating them as interchangeable 2 ton models.
CSAK-20 Specifications
| Category | Parameter | Specification |
|---|---|---|
| Technical Parameters | Max. Lifting Capacity | 2000kg |
| Length | 2350mm (excluding fork length) | |
| Width | 1200mm | |
| Height | 2150mm | |
| Total Vehicle Weight | 2900kg | |
| Lifting Height | 3000mm | |
| Body Material | New stamped steel body | |
| Electrical System | Travel Motor | 4000W AC travel motor |
| Voltage | 60V | |
| Controller | Anti-slope high-power controller | |
| Battery | 5 pieces of 70Ah maintenance-free lead-acid batteries | |
| Lights & Signals | Headlights, left/right turn signals, brake lights, driving lights, instrument panel, horn, etc. | |
| Chassis System | Drive Axle | Cast Steel Full-Floating 220 Axle |
| Tires | Front 650-10, Rear 500-8, C-grade solid tires | |
| Steering Axle | Heavy-duty forklift-specific rear axle | |
| Brake Type | Hydraulic service brake with hand parking brake | |
| Other Configurations | Lifting Cylinder | Double Hydraulic Cylinders with Reinforced Seals |
| Fork Length | 1220mm extra-thick forged forks | |
| Hydraulic Lifting Motor | 3000W AC Powered Hydraulic Motor | |
| Mast Material | C-section steel mast | |
| Steering Type | Hydraulic power steering | |
| Turning Radius | 90°in-situ steering | |
| Charging Time | 4-6 hours | |
| Continuous Working Time | 6-8 hours | |
| Climbing Angle | 15° |
Send us your working space, load weight and daily operating requirements if you are comparing CSAK-20 with another 2 ton CSTAR model.
